Skip Navigation
Choose language
1 Phase Start-up Current Limiter
According to IEC60947-4-2, DIN/EN60947, VDE0660
PCB version
Mod.No. 87000040
K700 with integrated start-up current limiter
Mod.No. 0098.7770
Aluminium case with integrated start-up current limiter
Mod.No. 0098.7772 - Schuko
Mod.No. 0098.7773 - CEE
Mod.No. 0098.7774 - Switzerland
Special features:
- Continuously variable current limit and start-up time
- Bypass relay for lossless operation
- Soft start, even when mains current is already applied (load detection)
- Best protection against triggering circuit breaker during start-up
- Automatic load detection
For use in:
- Chippers, saws, compressors, fans, angular grinders, stone cutting machines, asynchronous motors without control electronics etc.
Technical data:
- Operating voltage
- 230 V/50 Hz (sinusoidal)
- Max Switching capacity
- 3,600 W / 16 A
- Stat-up current limit
- 10 A ... 25 A adjustable
- Max. start-up time
- 30 s at 50 Hz (time-Out)
- Start-up delay
- Approx. 500 ms
- Load detection
- Min. 1 KW
- Intrnsic consumption
- 0.6 W
- PCB dimensions
- 75 x 54 x 25 mm (LxWxH)
- Power semiconductors
- 2 thyristors 25 A/1200 V
- Ambient temperature
- -15° C ... +50° C
- Conections
- Flat pin plug 6.3 x 0. 8 (PCB verson)
- Cable lengths for models in aluminium cases
- 2 m mains cable and 1 m connecting cable
1 mtr. Leitung mit Kupplung
Operating cycles (I/h):
| Start-up current |
Start-up time |
||
|---|---|---|---|
10 s |
20 s |
30 s |
|
| 16 A | 30 |
15 |
10 |
| 20 A | 25 |
12 |
8 |
| 25 A | 20 |
10 |
6 |
For use in series:
Circuit diagram [pdf-File]
Instruction manual [pdf-File]
Functional description:
The KLIBO 1 phase start-up current limiter is installed between the mains connection and the consumer. The control unit detects when the consumer is switched on and limits the start-up current to a set value, making the start-up smooth and protecting the drive. The current limit is adjustable and can be set to a value that will not trigger the circuit breaker.
The load detection is another feature highlight of this start-up current limiter. Many commercially available start-up current limiters only work for the first start-up when the consumer is plugged in or switched on. This causes problems when the device is installed between the mains connection and the consumer. When the motor is started for the second time, the soft start device has already been activated and does not limit the start-up current anymore. The motor will start with approximately 4 to 6 times its nominal current. This will not happen with our 1 phase start-up current limiter. It detects that the motor is switched on again, and thus can limit the start-up current every time the motor is started.
After start-up the KLIBO 1 phase start-up current limiter works virtually without loss and interference (no EMC interference).